Solar roof ventilation is a vent fan powered by solar energy. It is a great addition to the house as it normalises room temperature during extreme weather conditions. Such ventilation technology efficiently exhausts a lot of hot air over a day, cooling your home in the process. In winter, it helps remove the moisture that may cause roof damage and molds.
The ventilation system is also good for the environment as it lessens the household’s dependence on conventional power sources. Since it generates its power from the sun, it eliminates electric consumption costs for roof ventilation. Moreover, it is also easy to install at any location.
These are the seven easy step-by-step directions to install solar-powered roof ventilation.
Step 1. Prepare the tools for the installation
Safety harnesses, ladder, hammer, flat pry bar, utility knife, reciprocating saw, drill/driver, roofing cement and caulk gun are some of the basic tools needed for the installation. The tools that you need may vary depending on the design and specifications of the solar roof ventilation.
Step 2. Look for the right location
Solar roof ventilation sydney companies recommend the ventilation to be in an area with lots of sunlight exposure. Harnessing sunlight is crucial to its operation as it works best if it has enough supply of solar energy.
Step 3. Ladder up
Bring a ladder and lean it carefully into your chosen location. Ensure that the location has sufficient airflow throughout the roof. Position the vent next to ridge capping to avoid any leaks. Don’t forget to wear your harness when performing this step.
Step 4. Remove the shingles
Safety first. Wear gloves and protective eyewear before you mark the center of the chosen location and drill a hole into it. Outline the hole according to the perimeter of the roof vent. In case a drill is unavailable, you can always use a utility knife to cut the roof shingles outline.
Step 5. Cut the roof
Mark the center of the roof where you will place the vent. From the mark, cut the roof using a reciprocating saw. Remember to remove the shingles surrounding the perimeter.
Step 6. Place the vent
Apply roofing cement to the cut hole and place the solar roof vent evenly on it. Screw the vent flashing to the roof and apply caulking around it.
Step 7. Replace the removed shingles
Attach new shingles around the vent using the appropriate roofing nails. Apply caulking and roofing cement at the edge of the shingles that surrounds the vent.
See! As easy 1-2-3, anyone can install a solar-powered roof vent all by themselves. All you need is the set of right tools and materials and the perfect maxbreeze solar-powered roof ventilation to perform the task. As always perform these tasks with safety precaution.
Read Also:
2 Solar Panel Benefits: My First Solar Power Encounter
Factors That Affect the Solar Panel Efficiency (N)
